Clean the sieve surface once a week to keep sieve surface unblocked. Draw out the sieve with handle and clean it by using compressed air or steel brush. It is not allowed to strike the sieve surface with hammer to avoid distortion. Check sieve surfac
This machine is composed of sieve body with two layers of sieve surface, feeding device, discharging device, frame, and vibrating motor and vertical suction channel. Sieve body Sieve body is made of steel plate. The vibrating motor driving
In order to guarantee the safety when transporting, the sieve body is fixed to the machine frame by four pieces of protector angle steels (2). See Fig. 3. The protector angle steels are painted with yellow warning color.
1)Install the machine (see Fig 4, 5, 6, 7) When the machine is running, it produces the high changing load. This machine must be installed and fixed directly on the floor frame. If there is no floor frame under the installing position,
Commonly, the amplitude should be in the range of 5~5.5mm. The max amplitude is 6 mm. It is not allowed to exceed. Otherwise, the factory will not be responsible for any damage caused by this reason. You can read the amplitude value on the indicating
1.For this machine, there is only one place need lubrication, and they are bearing of vibrating motor. Lubricate the vibrating motor bearings with 3# grease or comparative oil every 2000 working-hours (about three months).